Garmin Flight Stream 110/210 Installation Manual - page 29
190-01700-00
Flight Stream 110/210 TSO Installation Manual
Rev. B
Page 4-2
4.3 Ground Checks
NOTE
A compatible PED with the Garmin Pilot Application is required to perform the ground
checks.
1. Check that the Flight Stream is paired with Bluetooth Device.
2. Check that Attitude is displayed on Bluetooth device (Flight Stream 210 only).
3. Check that the Flight Stream is oriented correctly (Flight Stream 210 only).
a) The GTN will forward attitude data from a G500/G600 system to the Flight Stream. For
these installations, the AHRS breaker needs to be pulled to perform this check.
b) With the wiring harness connected to the Flight Stream and the four, #6 screws removed,
gently roll the Flight Stream to the left and to the right. Check that attitude matches roll on
the portable electronic device.
c) Mount Flight Stream with four #6 screws. Turn the fasteners until snug and torque an
additional 1/4 turn.
d) Push in AHRS circuit breaker.
4. Check that the Flight Stream has a GPS position fix from the navigator or GDL 88, if connected.
(Aircraft must have a clear view of the sky.) A position fix is required to provide traffic and
weather.
5. If the Flight Stream is wired to a GDL 69, check that the XM WX data is being received and
displayed on the portable electronic device. (Aircraft must have a clear view of the sky.)
6. If the Flight Stream is wired to a GDL 69 and the Volume Lock discrete input is grounded, check
that the SiriusXM Satellite Radio volume controls on the portable electronic device are not
available or do not work.