Garmin MX20 Installation Manual - page 36
Installation
MX20 Installation Manual
29
2.7.2 External Data Source
This menu allows the software to assign ports to the installed sensors.
1. Press the DATA smart key while still in the INSTL function.
2. Ensure the External Data Sources pages of the MX20 have the desired configuration. Modifications
can be made using the line select keys. Port allocations must match how the system is wired. Set port
source to None if the hardware is not installed. The Internal GPS Position Source, when present, must
always be configured to Port 3. If the altitude data is supplied from the GX model or CNX-series unit
(or GNS 480), the Altitude Source port must be set to the same port number that the GX model or
CNX-series (or GNS 480) unit is connected to (such as Port 1 in the example shown below). When
the MX20 is connected to a CNX-series (or GNS 480) navigator with an internal NAV receiver, the
NAV Data Source on the MX20 must be set to NONE.
Main Menu
Next Page