Garmin NTX54-Nissan User Manual - Quick Start User’S Guide
12 |
P a g e
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product. If you do
not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger entertainment only.
NTX-54 Nissan/Infiniti Navigation System
wire:
Programming PINK ‘INPUT’ wire:
Setup:
IF YOU ARE NOT INSTALLING ANY AFTERMARKET CAMERAS OR VIDEO INPUT, SKIP THIS SECTION AND GO STRAIGHT TO THE
"OPERATION" SECTION.
Note:
-These programming sequences only need to be performed one time. To deprogram, just repeat the above step(s).
- If the factory image does not reappear, press anywhere on the touchscreen. When the screen returns the factory
image, the feature should be programmed.
When this wire is programmed, the screen will
display ‘Aux Video’ from the silver NTX54 module
when the PINK ‘INPUT’ wire sees 12v (+), regardless
of what source is currently displayed. This must be
programmed if adding a rear camera.
While in the factory screen mode, press and hold the
top right corner of the screen until the screen goes
completely black (this will take about 20 seconds).
Release the top right corner and wait until the
factory image can be seen again.
Quick Start User’s Guide
Programming PINK ‘INPUT’ wire for REV Cam: