Garmin NTX54-Nissan User Manual - page 7
7 |
P a g e
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
All other Nissan & Infiniti vehicle Radio & Screen Removal: Warning! The ignition MUST be off
Screen Replacement ALL VEHICLES EXCEPT FX.
Using a soft pry tool, pry around the outside of
the HVAC fascia to release the clips all the way
around. Pull the entire fascia towards the back
of the vehicle to release the clips, disconnect all
the wiring harnesses and set aside.
Using a soft pry tool, pry around the outside of
the HVAC fascia to release the clips all the way
around. Pull the entire fascia towards the back
of the vehicle to release the clips, disconnect
all the wiring harnesses and set aside.
Remove the screws around the monitor
bracket, unplug the monitor and set the
monitor and bracket aside.
The removal of all other Nissan and Infiniti vehicle radios are similar to either the G37 or Armada. Remove the radio
and screen from the vehicle and then proceed to the next steps. MAKE SURE that the ignition is off in all
Nissan/Infiniti vehicles as the airbag indicator light is on the part of the dash that you will be removing. Although
it will cause no damage to the vehicle, the air bag indicator malfunction light will illuminate if the ignition is turn
on while this indictor light is unplugged.
Mount the included touch screen monitor into the bracket, making
sure that the angle side is facing the mark, secure it with the factory
screws and reinstall the monitor back into the vehicle.
Mark the bracket on the side where the
monitor has an angle. Remove and retain the
2 screws on each side of the factory monitor
and remove it from the bracket.
Beveled
corner of
touchscreen
is the
bottom