Garmin nuvi 200 Series Setup Manual - Mounting On Your
10
nüvi00Seriessetupandgo!guide
Mounting on Your
Dashboard
Use the enclosed mounting disk to
mount your unit to the dashboard
and to comply with certain state
regulations.
iMPOrTaNT: The permanent
mounting adhesive is extremely
difficult to remove after it is
installed.
1. Clean and dry the dashboard where
you are placing the disk.
2.Removethebackingfromthe
permanentmountingadhesiveonthe
bottomofthedisk.
3.Placethediskonthedashboard.
4.Placethesuctioncupmounton
topofthedisk.Fliptheleverdown
(toward the disk).
Changing the Fuse
CauTiON: When replacing the
fuse, do not lose any of the small
pieces and make sure they are put
back in the proper place.
If your unit will not charge in your
vehicle, you may need to replace the
fuse located at the tip of the vehicle
adapter.
1.Unscrewand
removethesilver
orblack,roundend
piece.
2.Removethefuse(glassandsilver
cylinder) and replace with a 1A fast
blowfuse.
3.Ensurethatthe
silvertipisplaced
intheendpiece.
Screwontheend
piece.
Unscrew
end
piece
silvertip
fuse