Goldmund SRP2.3 User Manual - page 4
4
4 - CONNECTIONS
Connect the power cord to the back of the unit and plug it into the nearest wall plug. Use a 3
lugs grounded plug for safety. To get the best sound of the preamplifier, avoid any multiple
plugs or an extension cord.
Connect the interconnects between the preamp and the power amp. Plug the cables to the
RCA female sockets noted output.
Connect the interconnects from the source devices to the 5 inputs. Connect the tape
machines to TAPE input and output RCA plugs.
Note : If you have the digital input option, the inputs 3, 4 & 5 are not available anymore for
analogue sources. But inputs Digital 1 – 2 – 3 are active and may be connected to digital
sources.
Note : The analogue input 1 may be converted internally to a SSP Direct cinema input. Do not
use it for another source if you want to use this option. When set-up, the option is connecting
the input 1 to output bypassing all preamp circuitry. To activate the SSP option, just plug a
connecting Jumper on JP1 on the back of the circuit.
5 - CONTROLS AND UTILIZATION
- POWER ON
The GOLDMUND SRP2.3 preamplifier has no power switch. It is powered ON as soon as the
power cord is connected to the wall plug. It must remain connected all the time.
When powered on first, the preamp will become operative immediately. Do not power ON the
power amplifier immediately to insure proper stabilization of all the circuitry and avoid any
unwanted noises.
- VOLUME
Level adjustment acting simultaneously on both channels.
- SELECTOR
This selector allows to choose the source from one of the 5 inputs.