Goldmund SRP2.3 User Manual - page 5
5
- REMOTE-CONTROL
The SRP2.3 uses a volume motor-driven potentiometer which can be adjusted by the remote
controller provided for increasing (+) or decreasing (-) the sound level.
In addition a "MUTING" control with soft stop and start is available through the remote control
which acts on the potentiometer.
The additional "MEMO" key on the remote allows to pre-program a standard level to which
the potentiometer will return when the unit is powered on or when the "RESET" key is
pressed.
Attention :
If the potentiometer position you want to memorize is above the potentiometer's
half position, it won't be memorized and a value of
¼
will be memorized instead. This is
provided by the software as a safety to avoid very high level memorization by accident with
potential danger for the speakers the next time the unit is turned on.
6 - SOUND QUALITY OPTIMIZATION
- Warm-up sonic effect.
If the preamplifier has been left unpowered for a few days, the optimum sound quality is only
reached after few hours. The critical circuits have to warm up to around +55 degrees Celsius
(+131 degrees Fahrenheit) before achieving their optimal performances.
7 - MAINTENANCE
The GOLDMUND SRP2.3 preamplifier usually requires no maintenance. For the audio purists
who want to keep their preamp sounding as new, we only recommend that after a year or two,
you have a technician or an official GOLDMUND representative readjust the DC offset. This
very simple operation takes only two minutes and will give you the safety of long years of
unmatched sound quality.
To clean your preamplifier use only a soft, slightly wet cloth. Always turn the power off before
cleaning your preamplifier.