Review this manual before operating your prestige pro powerhead owner's manual p/n 80255 • 11/17.
Prestige pro powerhead 2 table of contents: subject page safety instructions ..........................................................................................3 using your prestige pro powerhead for the first time ................................ 4 general operation ............................
3 important safety instructions read these instructions before using this vacuum system when using an electrical appliance, basic precautions should always be followed, including the following: warning: to reduce the risk of fire, electric shock or injury: • unplug and disconnect power before servic...
Prestige pro powerhead 4 using your prestige pro powerhead for the first time warning: do not plug into electrical supply until assembly is complete. Failure to do so could result in electrical shock or injury. 1. Insert the wand into the opening located on the neck of the powerhead, it will click i...
5 general operation the prestige pro is controlled by pressing the three position on/off power control switch located on the hose handle. When the switch is pushed to the left (i) it turns on the vacuum only. When the switch is pushed to the right (ii) it operates both the vacuum and the brush rolle...
Prestige pro powerhead 6 performance features warning indicator light your powerhead is equipped with a circuit protector safety system that protects it from a possible jammed brush roller. The warning indicator light on top of the unit will change from green to red should a jam occur. If the circui...
7 maintenance and care warning: always unplug vacuum hose and wand before servicing and maintaining the prestige pro powerhead. Failure to do so could result in electrical shock or personal injury if unit suddenly starts. Always follow all safety precautions specified when caring for your prestige p...
Prestige pro powerhead 8 replacing the belt to replace the belt, you must first remove the brush roller, see “removing the brush roller” section on page 7. Belt 1. Locate and discard broken belt. To install new belt, locate the powerhead motor pulley and loop the belt around it. 2. Place the other e...
9 1. Turn the powerhead over and remove the bottom plate by first unscrewing the two bottom plate screws located by the rear wheels. 2. Remove the two top cover screws (located under the front wheels). Turn the powerhead back over, push the neck flat, and remove the top cover. 3. Simply pull the bul...
Prestige pro powerhead 10 h-p products, inc. Warrants that the prestige pro powerhead, when used for household purposes, pursuant to seller’s instructions, will be free from defects in materials and workmanship for a period of one (1) year from the date of the initial consumer purchase. H-p products...
11 limited warranty.
512 w. Gorgas street louisville, ohio 44641-0912 www.Centralvacservice.Com.
