H-P Products Prestige Pro Owner's Manual - page 9
of
12
9
1. Turn the powerhead over and remove
the bottom plate by first unscrewing
the two bottom plate screws located by
the rear wheels.
2. Remove the two top cover screws
(located under the front wheels). Turn
the powerhead back over, push the
neck flat, and remove the top cover.
3. Simply pull the bulb out (DO NOT
TWIST) and re-insert a factory-
authorized bulb. Place the top cover
back on the unit, turn the powerhead
over and re-insert the two top cover
screws. Re-install the bottom plate by
inserting the front end of the bottom
plate first. Re-insert the two bottom
plate screws and secure.
Remove
Screws
Replacing the Bulb