Haag-Streit BI 900 Instructions For Use Manual - page 9
9
DEUTSCH
ENGLISH
FRANÇAIS
ITALIANO
ESPAÑOL
NEDERLANDS
PORTUGUÊS
SVENSKA
DEUTSCH
ENGLISH
FRANÇAIS
ITALIANO
ESPAÑOL
NEDERLANDS
PORTUGUÊS
SVENSKA
© HAAG-STREIT AG, 3098 Koeniz, Switzerland - HS Doc. no. 1500.7220505-04010 – 2015 – 08
3.6 Step-by-step cabling
•
Place the release module RM02 (73) over the slit lamp's cross slide. Four mag-
netsareusedforfixing.
WARNING!
•
Keep magnet-sensitive storage media (e.g. credit cards) away from
the magnets on the release module RM02!
•
Only external medical power supplies approved by Haag-Streit that
fulfillEN60601-1maybeused.
•
Pull the cable headrest through the braided sleeving.
•
Connect the cable headrest with the counterpart on the headrest (67).
•
Mount the table top and place the slit lamp on the table.
•
Insert the camera cable connector plug (76) in the socket (85) on the RM02. In-
sert the other end in the camera carefully from below. Lay the cable in the recess
on the microscope arm (75).
•
Thread the computer cable USB 3.0 (73) and power supply cable (72) through the
braided sleeving (70) too.
•
Insert the connector plug of the power supply cable (72) in the socket (86).
•
Insert the connector plug of the computer cable USB 3.0 (73) in the socket (83).
•
Pull on the braided sleeving taught and mount a cable tie (69) on each end.
•
Mount a cable cover (91) on the threaded bolts (88) or mount the USB connec-
tor screws.
•
Connect the mating connector of the computer cable USB 3.0 (73) on the PC.
•
Connect the electric power supply lead (35) to the power supply (34).
•
Connect the power supply connector plug to the power grid.
•
Plug the lamp cable (1) into the illumination head.
67
68
69
70
71
72
73
73
74
75
76
77
67. Connection plug headrest
68. Connector plug headrest / LED illumi-
nation / RM02
69. Cable tie
70. Braided sleeving
71. Cable headrest / LED illumination /
RM02
72. Power supply cable
73. Computer cable USB 3.0 (3m long)
74. Camera (not shown)
75. Recess on the microscope arm
76. Connector plug camera cable
77. Release module RM02
78. RM02 operational control LED
79. On/Off key
80. Rotating knob, periphery or back-
ground illumination
81. Rotating knob, slit illumination
82. Selector key A
83. Selector key B
84. Release key RM02
85. Socket camera cable
86. Socket for power supply connec-
tor plug
87. Socket computer cable USB 3.0
micro B
88. Threaded bolt
89. Pin assignment without imaging set
90. Pin assignment with imaging set
91. Cable cover
76
78
79
73
72
71
80
81
82
83
84
81
82
87
85 86
71
89
88
69
90
91
69
34
35
01-IFU_BI900-7220505-04010_eng.indd 9
12.08.2015 14:37:56