Hahnel modus 600rt Instruction Manual - Wireless Flash
GB
GB
42
Modus 600RT - English
Modus 600RT - English
43
Wireless Flash
Photography:
(2.4GHz) using
Viper TTL Transmitter
5
Wireless Settings
DCM (Digital Channel Matching)
1. DCM (Digital Channel Matching). Carry out the DCM
matching, see page 28
2. Set the Modus 600RT to 2.4GHz as Slave Unit - Group
A,see page 27
3. Press Viper
08
button to confirm that Modus
Speedlight is triggered wirelessly
Viper TTL group Mode Setting
Press buttons
A
or
B
or
C
to change the
MODE setting
of each group to
Take a test photograph now and the Viper transmitter will
send a wireless signal to each Modus 600RT and to each
3rd Party Speedlight connected to a Viper TTL receiver.
The Speedlight will then be set automatically to the same
Viper TTL selected group mode setting.
• The Viper LCD
05
will show the setting of each group
• A group is turned OFF if the LCD is not showing the group
• A group is in Manual mode when
to the group
• A group is in TTL mode when
the group
• Each group
A
,
B
or
C
is set independently and it is
possible to use simultaneously different setting for each
group (e.g. Group
A
may be in
B
in
and Group
C
turned OFF)
Group Power Control setting for
Manual and TTL FEC
From the Viper TTL transmitter you can adjust the power
level and the
FEC of each group.
4. Press
02
select button and all three icons
and
5. Press one button
A
or
B
or
C
to select which group
you want to adjust the power. Now only the selected
group icon <
A or B or C> will flash
6. Use the adjust dial to set the power output in <
M
>
mode and
FEC in TTL mode
7. Press the
Multi Mode
• Press and hold the
< Group A > button to select
the Multi mode
<
MT
> icon. Use the
Group Buttons and adjust dial to set the number of
flashes, flash frenquency and power output. Press the
• For more detail on operation of the viper TTL visit www.
hahnel.ie
Sync Modes
• Press and hold the
< Group B > button to select the
High Speed sync < > icon will switch on
• For 2nd Curtain Press and hold the
< Group B >
button again - < > icon will switch on
• Press and hold the
< Group B > button again to go
back to normal sync