Hahnel modus 600rt Instruction Manual - page 24
GB
GB
46
Modus 600RT - English
Modus 600RT - English
47
C.Fn: Setting Custom Functions
The following table lists the available and unavailable
custom functions of this flash.
1. Software Version
Press
2 seconds or longer until C.Fn menu is displayed. The
“Ver x.x” in the topright corner refers to the software
version.
2. Select the Custom Function No
• Turn the Select Dial to select the Custom Function
number
3. Change the Setting
• Press
• Turn the Select Dial to set the desired option. Pressing
• After you set the Custom Function and press function
button 4, the camera will be ready to shoot.
4. C.Fn Default
In the C.Fn menu, a long press of the “Clear” button for
2 seconds until “OK” is displayed on the panel, which
means the values in C.Fn are reset to their default
options
Control with the Camera’s Menu Screen
If the camera flash is attached to an EOS camera
which has a speedlite control function, the flash can be
controlled using the camera’s menu screen. For the menu
operation procedure, refer to your camera’s instruction
manual.
Setting Camera Flash Functions
The following flash functions are settable according to
different flash modes.
1. Flash mode
2. Shutter sync (1st/2nd
curtain, high speed sync)
3. FEB
4. Flash exposure
compensation
5. Flash firing
6. Clear camera flash’s
settings
7. Custom Functions
of Camera Flash
C.Fn-00, C.Fn-01,
C.Fn-03, C.Fn-04,
C.Fn-08, C.Fn-10,
C.Fn-20 and C.Fn-22.
Clear All Flash Custom Functions
Protection Function
1. Over-Temperature Protection
• To avoid overheating and deteriorating the flash
head, do not fire more than 30 continuous flashes in
fast succession at 1/1 full power. After 30 continuous
flashes, allow a rest time of at least 10 minutes
• If you fire more than 30 continuous flashes and then
fire more flashes in short intervals, the inner over-
temperature protection function may be activated and
Flash C.Fn settings
Auto powe off
1
0:Enabled
1:Disabled
0 1 2 3 4 5 6 7 8 9 10 11 12 13
0 0 0 0 0 0 0 0 0 0 0 0 0 0
-
Flash function settings
screen
Flash C.Fn settings
screen
* Screens from the EOS-1D Mark III.
• If flash exposure compensation has already been set with
the speedlight, flash exposure compensation cannot be set
with the camera. To set it with the camera, the speedlight
flash exposure compensation must be set to zero
• If any Flash Custom Functions and flash settings other
than flash exposure compensation have been set by both
the camera and the flash, the latest settings will take
effect.