HAI OmniTouch 10 pe User Manual - Chapter 2
Manual is about: 10” Portable Color Touchscreen
of
40
8
Chapter 2
Getting Started
Installing the Rubber Bumpers
To protect the housing case of OmniTouch 10pe, install the
supplied rubber bumpers.
1. Install the rubber bumpers on the left and right side of
OmniTouch 10pe.
2. Make sure the rubber bumpers are aligned and locked on
the indents.
Removing the Rubber Bumpers
From the rear of the OmniTouch 10pe, remove the rubber
bumpers.
Using the Power Switch
The power switch, located next to the external battery contacts, controls the flow of power of your
OmniTouch 10pe. By default, the power switch is set on the left. To reveal the power switch, remove
the external battery contacts cover.
•
To cut off power flow - switch to the left
•
To allow power flow - switch to the right