Haier 10515222 Operation Manual - page 18

BLANK

TIMER ON

TIMER OFF

TIMER ON-OFF

Then select your desired TIMER mode (TIMER ON - OFF).

 "       "will flash.

Press HOUR           button.

   Every time the button is pressed, time setting increases

   1 min, if kept depressed, it will increase rapidly.

   Every time the button is pressed, time setting decreases

   1 min, if kept depressed, it will decrease rapidly.

   It can be adjusted within 24 hours.

After setting correct time, press TIMER button to confirm

"       " on the remote controller stops flashing.

"        " starts flashing.

Time displayed: Unit starts or stops at x hour x min.

After time setting,press SET button to confirm.

"      " on the remote controller stops blinking.

Time displayed:Unit stops at x hour x min.

Operation

Remote Controller

Timer On-Off Operation

Just press TIMER button several times until TIMER

mode disappears.

According to the Time setting sequence of TIMER ON

or TIMER OFF, either Start-Stop or Stop-Start can be

achieved.

Set clock correctly before starting

TIMER operation.

1. After unit starts, select your

    desired operation mode . Operation mode will be

    displayed on LCD.

2. Timer mode selection

    Press TIMER button to change TIMER mode. Every time

    the button is pressed, display changes as follows:

    Remote controller:

3.Time setting

4.Timer confirming for TIMER ON

5.Time setting for TIMER OFF

6.Time confirming for TIMER OFF

To cancel TIMER mode

Just press HOUR button ,follow the same procedure in

"Time setting for TIMER ON"

Display board

POWER/SOFT

FRESH

16