Haier H2SM-(9+12)HEK03/R2 Operation Manual - page 2
2
Outdoor Unit
Loading of the battery
1
2
3
4
Parts and Functions
Indoor Unit
OUTLET
INLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
Remote controller
Remove the battery cover;
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
is in line with th
e" + "/"-";
Load the battery,then put on the cover again.
Clock set
Press CLOCK button, "AM" or "PM" flashes.
Press or to set correct time. Each press
change quickly. After time setting is confirmed,press SET,
"AM "and "PM" stop flashing,while clock starts working.
or decrease 1min. If the button is kept pressed,time will
will increase
14.TIMER ON display
8 . FAN SPEED display
11. LOCK display
9 . SWING display
Operation mode
AUTO
FAN
COOL
DRY
Remote controller
10. Operation mode display
16 .
13.
TEMP display
15.
TIMER OFF display
17.
CLOCK display
ON/OFF button
18. TEMP button
1.LOCK button
4.
6. FAN button
TIMER button
20. HOUR
HEAT
12.Singal sending display
2.
CLOCK
When the remote controller
22. RESET
button
button
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-sta rted type fluorescent lamp or change- over
wireless telephone is installed in the
ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
type fluorescent lamp or
room, the recei
Note:
Full display or unclear display during operation indicates the
ries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
reload several minutes later.
batte
remove the batteries and
appears abnormal,use a
sharp pointed article to press
this button to reset the remote
controller normal.
3.
SET
5. SWING button
7. SLEEP display
button
button
19.MODE button
21. SLEEP button
Please be subject to the actual produce purchased the
above picture is just from your reference
Please be subject to the actual produce purchased the
above picture is just from your reference
7
11
12
13
14
15
17
18
19
20
21
10
9
8
16
6
5
4
3
2
1
22
ON/OFF
MODE
SET
FAN
TIMER
SWING
CLOCK
SLEEP
LOCK
RESET
SET
TIMER
CLOCK
SLEEP
LOCK
RESET
Air Purifying Filter
(inside)
Inlet
1
Inlet grille
2
Outlet
3
(adjust left and
Vertical blade
right air flow
4
Display board
Horizontal flap
(adjust up and down air flow.
Don't adjust it manually)
Emergency Switch
6
7
8
5
1
2
3
4
5
6
7
8
AUTO
LO
MED
HI
Used to lock buttons and
LCD display.
4
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.