Haier HD90-A636-F Instructions Manual - page 20
CLEANING & CARE
TUMBLE DRYER
Wipe the outside of the tumble dryer and the control panel with a damp cloth. Do
not use any organic solvent or corrosive agent to avoid damage to the device.
DRUM
After some operation time, fabric care agents or calcium contained in the water
some detergent to remove it. Do not use any organic solvent or corrosive agent
to avoid damage to the device.
EVAPORATOR
a vacuum cleaner. Make sure not to damage the evaporator while cleaning it.
ERROR CODES
CODE
CAUSE
SOLUTION
20 | English
If the evaporator behind the condenser filter is dirty, it can be cleaned by use of
F2
Drain pump error.
Contact the customer service.
F32,
F33
The condenser thermal
sensor is open-circuited or
short-circuited.
Contact the customer service.
F4
Temperature of the laundry
in the drum does not
change.
Contact the customer service.
E6
The filters is clogged.
Clean both filters.
Lo
Use the dryer when air temperature
is higher than 5
Temperature is too low.
F5
Contact the customer service.
Communication failure
between PCB and display.