Haier HSU-09HEA03 Operation Manual - page 7
Parts and Functions
NOTE:
1. Operation mode display
24. HEALTH
Used to operate the healthy function
.
Hints
After replacing with new batteries, remote controller will conduct self-check, displaying
all information on LCD.Then, it will become normal.
Display board
25
Ope
r
ation mode AUTO
FAN
COOL DRY
Remote controller
Display board
25. Singal receiver hole
26. Ambient temp.display
When receiving the remote control signal, display
the set temperature and in the rest time the room
temperature is displayed and this room temperature
is only for reference.
26
23
1
7 8
1
Remote controller
Clock set
When unit is started for the first time and after replacing batteries in remote controller,
clock should be adjusted as follows:
Press CLOCK button, "AM" or "PM" flashes.
Press or to set correct time. Each press will increase or decrease 1min. If the
button is kept depressed, time will change quickly.
After time setting is confirmed,press SET,"AM "and "PM" stop flashing,while clock starts working.
9
HEAT
1
Cooling only unit do not have displays and functions related with heating
.
2. SWING display
3.FAN SPEED display
4. SLEEP display
5. LOCK display
6. SIGNAL SENDING
7.TIMER OFF display
8. TIMER ON display
9. CLOCK display
10. TEMP display
11. POWER ON/OFF
Used for unit start and stop.
12. MODE
Used to select AUTO run, COOL,DRY
HEAT and FAN operation
13. FAN
Used to select fan speed LO, MED, HI, AUTO
14. HOUR
Used to set clock and timer setting.
15. SWING
Used to set auto fan direction.
16. SLEEP
Used to select sleep mode.
17. LOCK
Used to lock buttons and LCD display.
18. TEMP.SETTING
Used to select your desired temp.
19. SET
Used to confirm timer and clock settings.
20. TIMER
Used to select TIMER ON,TIMER OFF,
TIMER ON-OFF
21. CLOCK
Used to set correct time
22. RESET
normal condition.
Used to reset the controller back to
LO
MED
HI
AUTO
1
2
3
5
6
7
8
9
10
4
ON/OFF
HEALTH
FAN
MODE
SWING
TIMER
CLOCK
SET
SLEEP
LOCK
RESET
11
12
14
15
16
17
13
18
19
20
21
22
24
23
23. HEALTH display
6