Holland Grill BH421SG-4 Tradition LS Instruction Manual - page 9
T-6
®
FIGURE 5
Chip Drawer
Bracket
Drain Pipe
Drip Pan
Drain
Valve &
Bucket
Tank
Retainer
Utensil
Holder
Step 5.
Refer to Figure 5. Select the following items:
18. Chip Drawer guide 21. Brass wheel valve
19. Drip pan 22. L.P. Tank top brace
20. Drain Pipe 23. Utensil Holder
Open the grill lid. Install the Chip Drawer Guide into the
right front corner of the grill body using 3, #5-40 bolts “I,
J, K” , lock washers and nuts
The Utensil Holder attaches to a shelf bracket with (2)
“L” screws. It may be installed on either side
Install the short length of Drain Pipe in the female
threaded coupling in the right end of the drip pan.
Tighten with pliers or pipe wrench
Place the Drip Pan into the grill bottom using the lift tabs
at each end as handles. Line up the drainpipe with the
hole in the grill bottom and body support bracket, making
sure pipe extends out bottom and drip pan is sitting level
in its brackets
Install the Brass Drain Valve by threading it onto the
end of the drain pipe extending from the bottom of the
grill. Hand tight is sufficient. Hang drip pail on the drain
Valve
Tank Installation
Place your full 20-lb. propane tank into the hole of
the grill base. Install the Tank Hold -Down Bracket
using the wing nut and adjust to secure the tank. You
may need to rotate the tank to find a suitable area
for the Hold Down Bracket to engage.
Screw the QCC-1 regulator onto the propane tank
valve by hand. The large plastic nut fits over the
outside of the tank valve threads and turns right, or
clockwise, to tighten. No tools are needed.
If a good connection is not achieved, the safety
valve inside the QCC-1 regulator will not permit the
proper amount of gas to flow. The only way to know
it the proper amount of gas is getting to the burner is
by looking at the flame once the grill is lit. If the
flame looks very small, simply unscrew the
regulator, wait a few minutes and re-attach. This will
re-set the QCC-1 safety valve.
Check all bolts and nuts for tightness and proceed to
gas leak testing.
❍
❍
❍
❍
❍
❍
❍
❍
❍
QCC-1
regulator