Holux CR-100 Quick Installation Manual - page 6
0.1 Choose an appropriate holder model to go with your PDA.
Model PDA
type
CR100-I1
IPAQ 38xx,39xx
CR100-P1
Palm TUNGSTEN T3
CR100-D1 Dell
X3
CR100-M1 Mio
528
CR100-I2 IPAQ
2210
0.2 Pull the arms of a clamp out from both sides of the holder
and gently place your PDA on the base of the holder. Make
sure that the socket of your PDA is connected properly to the
PDA connector of the holder for the installation.
0.3 Connect one end of the audio cable to the sound connector
of your PDA and the other end to the Holder SPK IN
connector of the holder.
0.4 Insert one end of the car battery adapter into the cigarette
lighter socket of your car. After the power is connected,
both of the LED indicator (Green Light) of the base and the
LED indicator (Orange Light) of the GPS are lit
simultaneously, which stands for having a normal power
supply.
0.5
Adjust the position of the GPS antenna to the best
receiving position (with the antenna facing the sky), and the
holder will automatically adjust its position according to the
receiving conditions and output data to the PDA. After
the GPS receiver completes its 3D positioning, the green
LED indicator will blink once every second.