Holzfaller G3MT User Manual - page 12
12
STEPS FOR STARTING YOUR MACHINE (PERFORMED ON A PREVIOUS MODEL)
STEP 1
Fill the fuel tank with fuel and the oil tank
with oil. (Refer to page 13)
STEP 4
Slide the take on switch to the
down posi on.
STEP 7
Pull the recoil 2–4 mes. By the fourth
pull, it should sound like the engine is
going to start. Move to Step 8.
STEP 2
Press the fuel bubble 5–7 mes (no
more than 7). Fuel should now fi ll the tube
next to pump.
STEP 5
Squeeze the top and bo om levers
in and hold in fi rmly (as pictured in 5.2).
STEP 8
Slide the choke down to the bo om
posi on for the fi nal star ng and running
opera on of the machine.
STEP 3
Slide the choke to the up posi on.
STEP 6
While holding top lever and bo om
lever squeezed in, slide down or push in
the locking switch.
STEP 9
Pull the recoil once again, or un l
the engine starts.
CHOKE SETTINGS
OFF POSITION:
IS FOR INITIAL STARTING
ON POSITION:
IS FOR THE RUNNING OPERATION OF THE MACHINE
ALWAYS STORE MACHINE IN AN UPRIGHT
POSITION. NEVER STORE IT UPSIDE DOWN OR ON
THE LEFT OR RIGHT SIDE OF THE MACHINE. THIS
WILL AVOIDE EXCESS OIL LEAKAGE AND
INTERNAL DAMAGE.
12
STEPS FOR STARTING YOUR MACHINE (PERFORMED ON A PREVIOUS MODEL)
STEP 1
Fill the fuel tank with fuel and the oil tank
with oil. (Refer to page 13)
STEP 4
Slide the take on switch to the
down posi on.
STEP 7
Pull the recoil 2–4 mes. By the fourth
pull, it should sound like the engine is
going to start. Move to Step 8.
STEP 2
Press the fuel bubble 5–7 mes (no
more than 7). Fuel should now fi ll the tube
next to pump.
STEP 5
Squeeze the top and bo om levers
in and hold in fi rmly (as pictured in 5.2).
STEP 8
Slide the choke down to the bo om
posi on for the fi nal star ng and running
opera on of the machine.
STEP 3
Slide the choke to the up posi on.
STEP 6
While holding top lever and bo om
lever squeezed in, slide down or push in
the locking switch.
STEP 9
Pull the recoil once again, or un l
the engine starts.
CHOKE SETTINGS
OFF POSITION:
IS FOR INITIAL STARTING
ON POSITION:
IS FOR THE RUNNING OPERATION OF THE MACHINE
ALWAYS STORE MACHINE IN AN UPRIGHT
POSITION. NEVER STORE IT UPSIDE DOWN OR ON
THE LEFT OR RIGHT SIDE OF THE MACHINE. THIS
WILL AVOIDE EXCESS OIL LEAKAGE AND
INTERNAL DAMAGE.