Holzfaller G3MT User Manual - Operating The Pruner
8
ͫ
Hook the strap hook to the outer pipe on the sha
of the machine
ͫ
Wear the strap so that the hook stays at your right hand side.
ͫ
Adjust the length of the strap so that it is comfortable and at the
correct length whilst opera ng the pruner.
ͫ
In emergency situa ons unhook the metal clasp, this will release
the machine from the strap.
Please View Mega Machine Warehouse Help Videos For Installation.
of Poles and Starting Sequence For Operation Of This Machine.
OPERATING THE PRUNER
INSTALLING THE BAR AND CHAIN
NEVER ATTEMPT TO INSTALL, REPLACE, OR ADJUST THE CHAIN WITH THE ENGINE RUNNING!
WARNING! THE SAW IS VERY SHARP. WEAR GLOVES TO PROTECT YOUR HANDS WHEN HANDLING.
1Ή
Using the small end of the plug wrench remove sprocket
cover nut (turn counterclockwise to remove).
3Ή
Install the chain loop over the drive links within the guide bar groove, and then align the chain over the drive sprocket.
Make sure the cu er are properly oriented as shown in the picture below.
2Ή
Place the guide bar over the guide bar adjustment stud
on the cu ng head assembly. Align the chain tension pin
with the hole in the guide bar.
4Ή
Install the sprocket cover over the bar stud.
Using
fi nger-pressure only, install the
sprocket cover nut.
8
ͫ
Hook the strap hook to the outer pipe on the sha
of the machine
ͫ
Wear the strap so that the hook stays at your right hand side.
ͫ
Adjust the length of the strap so that it is comfortable and at the
correct
length whilst opera ng the pruner.
ͫ
In emergency situa ons unhook the metal clasp, this will release
the machine from the strap.
Please View Mega Machine Warehouse Help Videos For Installation.
of Poles and Starting Sequence For Operation Of This Machine.
OPERATING THE PRUNER
INSTALLING THE BAR AND CHAIN
NEVER ATTEMPT TO INSTALL, REPLACE, OR ADJUST THE CHAIN WITH THE ENGINE RUNNING!
WARNING! THE SAW IS VERY SHARP. WEAR GLOVES TO PROTECT YOUR HANDS WHEN HANDLING.
1Ή
Using the small end of the plug wrench remove sprocket
cover
nut
(turn counterclockwise to remove).
3Ή
Install the chain loop over the drive links within the guide bar groove, and then align the chain over the drive sprocket.
Make sure the cu er are properly oriented as shown in the picture below.
2Ή
Place the guide bar over the guide bar adjustment stud
on
the cu ng head assembly. Align the chain tension pin
with the hole in the guide bar.
4Ή
Install the sprocket cover over the bar stud.
Using fi nger-pressure only, install the
sprocket cover nut.