Holzmann D300F User Manual - page 31
OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Seite 31
DRECHSELBANK / WOOD TURNING LATHE D 300F
14.2
Operation
14.2.1
Tailstock adjustment
Move the tailstock (5) by loosening the lock lever
(1) and pushing the tailstock to the desired position
on the bed. Lock by tightening the lock lever (1).
The spindle can extend up to 2 1/2" from the
tailstock housing. You can move the tailstock
spindle (4) by loosening the spindle lock lever (2)
and then turning the hand wheel (3). Turning the
hand wheel clockwise extends the spindle; turning it
counterclockwise retracts the spindle. Lock the lock
levers (1) and the spindle lock levers (2) before
operating the lathe.
The tailstock spindle is hollow and can be accessed
from the handwheel end. Use the push-out rod to
remove the center cup or to drill holes through the
center of a workpiece on a faceplate.
14.2.2
Tool rest adjustment
To move the tool rest base (1), loosen the lock lever
(4) and move the base to the right or left and back
or front. Tighten the lever (4) when the tool rest
base is in the desired position.
To adjust the angle of the tool rest (2), loosen the
lock lever (3), move the tool rest to the desired
position, and tighten the lock lever.
To change to the other tool rest, loosen the lock
lever (3) and pull the tool rest (2) out of the tool rest
base, insert the other tool rest, adjust to desired
position, and tighten the lock lever (3).
N O T I C E
The tool rest should be selected as close as possible to the
workpiece!
Height adjustment just below the centerline of the workpiece.
Rotate the workpiece by hand and check that the workpiece can
rotate freely before turning!
14.2.3
On-Off-switch
Switch on: Push the green button ("I") for 2 seconds. The machine begins to
run.
Observe the circuit breaker reset button (2).
Switch off: Push the red button ("0").
The machine does not stop immediately! Stay as long at the machine, until the
workpiece is completely stopped (Do not stop the workpiece by hand!)
14.2.4
Speed adjustment
The speed of the D300F is infinitely variable with the speed controller (3) in a
range of 750 – 3200min
-1
after switch on (1) adjustable.