Holzmann D300F User Manual - page 32
MAINTENANCE
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Seite 32
DRECHSELBANK / WOOD TURNING LATHE D 300F
15
MAINTENANCE
ATTENTION
Don’t clean or do maintenance on the machine while it is still
connected to the power supply:
Damages to machine and injuries might occur due to unintended
switching on of the machine!
Therefore: Switch the machine off and disconnect it from the power
supply be-fore any maintenance works or cleaning is carried out
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all con-
necting parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the machine.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
NOTICE
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a
pre-requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
15.1
Maintenance plan
After each workshift:
Clean the machine and its parts with a strong jet of compressed air from wood dust and other
material remains. Moving parts can also be cleaned with a brush or a soft brush. Apply a thin
layer of lubricating oil to all moving parts of the machine.
After 50 hours of operation
Check the V-belts.
Determine for frayed belts cause. Check if uneven or rough surfaces and were built on the V-belt
pulleys. Replace frayed or stretched belts!
15.2
Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
NOTICE
The usage of certain solutions containing ingredients damaging
metal surfaces as well as the use of scrubbing agents will damage
the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution