Homak BL06034020 Owner's And Operator's Manual - Assembly Instructions
- 2 -
1. Before assembling parts, please check the parts quantity according to
the PARTS LIST.
2. Carefully unpack and spread out all parts in a large uncluttered area.
3. Familiarize yourself with all parts and compare them with the drawing
below to make sure none are missing. Read all assembly instructions
before beginning.
Assembly Tools
ASSEMBLY INSTRUCTIONS
Tools Needed for Assembly:
Model# BL05500200 / BK05500200
35” Service Cart with 3 Drawers
Assembly Tools
PLEASE CALL 1-800-874-6625 OR VISIT WWW.HOMAK.COM FOR WARRANTY OR PART
REPLACEMENT QUESTIONS.
10 mm
or
#3
Phillips
Bolt Kit (#6) included for attaching legs and
tray to BL05500200/BK05500200 cart:
12
(8)
10
(16)
11
(12)
9
(8)
7
(2)
8
(6)
Homak Manufacturing
1605 Old Route 18
Suite 4-36
Wampum, PA 16157
This product is not a toy and is not
intended for use by children.
STEP 1 Place the locking top and drawer unit (#1) on its back. Carefully open the locking top and its’
back against the ground.
STEP 2 Slide chrome legs (#2) into square holes in corners of locking top (#1) until bolt holes are
aligned at top of legs.
STEP 3 Determine on which side of the cart the side push handle (#17) will be mounted. Tehn, insert
two long bolts (#7) with two flat washers (#10) and lock washers (#12). Repeat this procedure for other
corners using short bolts (#8).
STEP 4 Slide bottom tray (#16) onto legs and fasten as in Step 3.
STEP 5 Mounting casters: Put the four casters in place. The two locking casters (Part #3) should be on
one side of the cart (recommend same side as push handle) and the two non-locking casters (Part #4)
should be on the other (left or right side, NOT front or back). Using the 16 bolts, 32 washers and 16
fasteners (located in Casters Hardware Kit, Part #5) completely tighten the casters to the bottom tray
using a 13mm socket and 14mm combination wrench for the bolt head. (Note: Bolt head and one washer
should be on the inside of the bottom shelf, nylock nut and one washer will be on the caster side.)
STEP 6 Return cart to upright position.
STEP 7 Using the screws (#11) provided, install drawer handles by aligning pre-drilled holes in drawers
with slots in handle. Tighten all screws securely.
13
14
15
16
3
4
4
2
17
1
PARTS LIST
A) Body
B) Bottom Shelf
C) 2 Legs
D) Push Handle
E) 2 Keys
F) 4 Casters
G) Hardware Package
2 Long Bolts
10 Short Bolts