Home Controls VistaCam 1100 Setup Manual - page 8
5
1. LAN port
The supplied Ethernet cable can provide the power
to the Waterproof HD IP Camera and also connect
the device to your router.
Note:
•
The Wireless and LAN interfaces cannot be
used simultaneously. Recommended to use
Y-cable for RP131 configuration only. The LAN
cable should be always connected in order to
provide electrical power to the camera.
•
The wireless interface will be disabled only
when the RP131 is power off or disconnected.
2. Reset
Button
This button is recessed; a pin or paper clip can be
used to press it. It can be activated at any time
when the camera is powered on.
•
Reset to default manufacturer values and
reboot. When pressed and held for 10 seconds,
settings of the Waterproof HD IP Camera will be
set to their default manufacturer values.
Note: After this procedure is completed, the
LED will blink once to confirm that the reset was
successfully completed.