Home Controls VistaCam 1100 Setup Manual - page 9
6
Setup the VistaCam 1100 Waterproof HD IP Camera
Step 1 - RP131 Configuration
This configuration will set wireless connectivity of the camera via
RP131.
1. Assemble the Camera
A. Hold the screw of the camera up.
B. Attach the back of the camera to the stand and turn the camera
clockwise to attach it to the stand.
C. Attach the rubber hood and screw to the LAN cable.
2. Connect the Camera
A. Connect the yellow connector of the provided Y-cable to the
Wireless PoE Adapter and the white connector to a Home
Gateway.
B. Use the Ethernet cable to connect the LAN port of Y-cable and
the camera.
C. Connect Wireless PoE Adapter to the power outlet. Please refer
to the manual for the WiFi configuration.
VistaCam 1100
3. Check the LEDs
The Power LED will start blinking during startup. After startup is
completed, the Power LED should remain ON.
4. Wireless Configuration (RP131)
Push the WPS button on the RP131 and on your router to establish an
encryption-secured wireless connection between the camera and the
router automatically.