I-GO Crest CSS User Manual - page 28
PAGE 26
8. TROUBLE SHOOTING & SPECIFICATION
Error Indication
»
If there is an error with the system when it is powered up, then the status
indicatorwillflashred;thenumberofflasheswillindicatethetypeoferror.
»
The table below describes the error indication and a few possible actions that
can be taken to rectify the problem. The actions listed are not in any particular
order and are suggestions only; the intention is that one of the suggestions may
help you clear the problem. If in doubt, consult your supplier.
Flash Code
1
Error Description
Remote / Joystick error
Possible Action
Check cables and connectors
Replace Remote
Networkorconfigurationerror
2
Check cables and connectors
Check Bluetooth pairing
Reconfigurethesystem
Recharge the battery
Check charger
Replace modules
Contact supplier
3
Left motor error
Check cables and connectors
Replace Power Module
Check and / or replace left motor
4
Right motor error
Check cables and connectors
Replace Power Module
Check and / or replace right motor
Left park brake error
5
Check cables and connector
Check left park break is released
6
Right park break error
Check cables and connectors
Check right park break is released
7
Module error (other
than Remote)
Check cables and connectors
Check modules
Replace LiNX Access Key
Replace Power Module
Recharge battery
»
Theerrorindicatormaycontinuetoflashafteranerrorhasbeenrectified.To
clear the error indication, cycle the system’s power.