I-SENS CareSens N Pop Owner's Booklet - page 6
8 www.i-sens.com
www.caresens.co.nz 9
The CareSens N POP meter uses two 3.0 V lithium batteries.
Before using the meter, check the battery compartment and
insert batteries if empty.
When the
symbol appears on the display while the meter
is in use, the batteries should be replaced as soon as possible.
The test results may not be saved if the batteries run out
completely.
Inserting or Replacing the Batteries
Step 1
Make sure the meter is turned off.
Press down and slide off the battery
compartment cover.
Step 2
Remove the old batteries one by one by
lifting with the index finger and pulling it
out with your thumb and index fingers as
shown in the diagram on the right. Insert
two new batteries with the + side facing up
and make sure the batteries are inserted
firmly.
Step 3
Place the cover on the battery
compartment. Push it down until you hear
the tab click into place.
Note:
Removing the meter batteries will not affect your
stored results. However you may need to reset your meter
settings. See page 13.
Caring for Your System
Use a soft cloth or tissue to wipe the meter exterior.
If necessary, the soft cloth or tissue might be dipped in a small
amount of alcohol.
Do not use organic solvents such as benzene, or acetone, or
household and industrial cleaners that may cause irreparable
damage to the meter.
Caution:
•Do not expose the meter to direct sunlight, heat, or excessive
humidity.
•Do not let dirt, dust, blood, or water enter into the meter’s test
strip port.
•Do not drop the meter or submit it to strong shocks.
•Do not try to fix or alter the meter in any way.
•Keep the meter away from strong electromagnetic fields such
as cell phones and microwave ovens.
•CareSens N POP meter should be used only with the CareSens
N test strips.
•Store all the meter components in the carrying case to
prevent loss and help keep the meter clean.