IAG IOGFS Installation And Operation Manual - page 12

PCI  "Campanil"TR 259 Analogic (Fig. 7L)

Setting the clock

Pull the control knob and turn clockwise.

Alarm programme adjustement

Turn the knob clockwise without pulling it in.

At the end of the programmed time an alarm will

sound. To cancel it, turn the knob to the bell.

Turn the knob clockwise, stopping the pointer

in line with the selected time.  The timer can be

set from 1 to 60 minutes. When the preset time

is over, a buzzer will sound.

XII

XI

X

IX

VIII

VII

VI

V

I

II

III

IV

Fig.  7L

Fig. 7M

1  Time of the day

2  Timing and insertion

3  Signal timng and insertion

Fig.  7N

12

MINUTE COUNTERS (fig. 7N)

O

45

5

35

25

15

55

Reset timer

Press “+” and “-” buttons together and release

“+” button first.

Signal

The signal after time out will stay 7 minutes if it

has not been reset with the “+” button (one touch

only).

Signal frequency

When the display shows the time of day, the signal

frequency can be selected by pressing the “-”

button. Three different frequencies are selectable.

ELECTRONIC TIMER FOR COOKER (Fig. 7M)

Functions

On

The display flashes.

Time setting

Press the left button.

Set the time with buttons “+” and “-”.

This function remains activated 7 seconds after

the last +/- operation.

Timer setting

This function is permanently activated and it will

be immediately set with +/- buttons.

During setting the units are 10 seconds.

During count down the timer takes priority on the

display.

The units are seconds.

The maximum time is 99 minutes.

The relay contact (when available) is closed during

the count down only.