IAG IOGFS Installation And Operation Manual - page 5
When the installation is complete, always check that all the unions are absolutely tight using a
soapy solution. Never use a flame to make this check.
IT IS RECOMMENDED THAT A SERVICE TAP AND UNION BE
FITTED ADJACENT TO THE APPLIANCE INLET TO FACILITATE
FUTURE SERVICING.
5
ELECTRICAL CONNECTION
The appliance must be installed by a suitably qualified person in accordance with
these instructions and with the requirements of the Australian Wiring Rules AS/NZS 3000.
Fixed wired installations are to be provided with suitable isolation means in accordance with the said
rules.
Any plug socket installed for the purpose of connecting the appliance to supply must be readily
accessible when the appliance is installed.
Before making the connection, make sure that:
1) the safety circuit-breaker and the electrical system are able to withstand the load of the appliance
(see nameplate).
2) the power supply system has an earth connection in good working order in accordance with the
regulations in force;
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
GREEN & YELLOW...............................................................EARTH
BLUE.................................................................................NEUTRAL
BROWN ....................................................................................LIVE
Electric power
Gas appliances with electric grill................3X1 mm
2
core cable (10 amp. Fuse required)
Should conform to local authority requirements.
Also refer to rangehood manufacturers recommendations.
This appliance is supplied with a plug & cord, simply plug into a 3 pin household socket outlet witch
is properly earthed.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The flexible mains lead and plug must not be in contact with hot surfaces.
CONNECTIONS
The Gas Connection is male 1/2" BSP and is situated at the right hand rear of the appliance, 20 mm
from the side and 500 mm from the bottom of the oven.
Should conform to local gas authority requirements.
Also refer to rangehood manufacturers recommendations.
Where there is limited access to the gas regulator or pressure test point, the regulator can be installed
inside an adjacent cupboard at the end of the hose assembly.
VERY IMPORTANT FOR THE INSTALLER
Do not attempt to turn or stress threaded elbow of the manifold: you risk damage to this part of the
gas appliance which may void the manufacturers warranty.
Apply a manometer to the test nipple and reset the regulator if necessary.
Check the burners pressure (grill and oven) all operating on high flame.
Do not forget to replace the test nipple screw and to leave the instructions book with the user.
Important: several parts are protected with a special anti-scratch film. Please remove it before use.