IBeam TE-360 User Manual - page 8
7
Note: Please pay attention to the definition of the wires when cutting wire connection.
white control wire, red camera power wire (5V), transparent wire for video, Shielding bare
copper wire is for GND.
6.Position and orientation of the cameras installation adjustment
1). Following the below steps to adjust cameras location
Connector Name
Functions
Serial port
⑦
The power
indicator light
For function extension
The indicator light will flash for 3-seconds while
power on ,then light up
4). Refer to above diagram, learn the connector function
3) The main box connection diagram (below diagram)
⑥
A,install the front and rear
view cameras according to the
position.
B,when install the left and
right cameras,please check and
see the distance if same from
the front /back wheels to the
lower end of screen according to
AV1/AV2,if not same,please
rotate the left and right
cameras to reach same
distance.(as image 1:A=B)
Note: the location installation and mounting
opening way of the left and right cameras:
Camera mounting drill diameter is 19.2mm, try
to put the hole location on the edge of the
mirror as much as possible (outside), the farther
located, the better quality of seamless joint pictures
will be, the two oblique rings are used to fixed
the cameras always turns downward vertically,
the plastic ring is used to beautification the
opening, opening holes should pay attention to
the both sides be similar, cannot block the lens to
mobilize, refer to the right picture:
oblique
ring
plastic
ring
6
PIC 1
PIC 2
A
B