IBM -3460 Installation And Operating Manual - page 10
The Data Jack
The jack located on the side of the telephone
labeled "DATA" is a convenience jack. It is useful
for connecting a fax machine or modem when
there is no telephone jack available for that
device.
The Headset Jack
The headset jack is located on the right side of
the handset and is a standard 2.5mm plug.
Simply plug the headset into the jack and the
headset will be active.
Note: When the headset is plugged into the
telephone, the microphone and earpiece
on the handset are not active.
Belt-Clip
Install the belt-clip as shown.
18
H
EA
DS
ET
Data Jack
Headset Jack
Belt-clip
17
HEADSET AND DATA JACK
Battery Installation
To install the 3.6V 600mAh cordless handset battery pack:
1. Slide open the battery compartment door on the back of the handset.
2. Plug the battery connector into the 2-pin connector in
the battery compartment, and then insert the battery.
3. Close the battery compartment door.
4. Place the handset on the base unit cradle.
5. Once you have installed the battery pack and placed
the handset on the base you will hear a tone
indicating the handset has connected with the base
and will successfully charge.
6. IMPORTANT: Charge the battery pack for at least 12
hours before using the handset the first time.
7. The CHARGE LED on the base will light when the
handset is properly making contact with the charge
terminals.
Battery Duration
A fully charged battery lasts for approximately:
• 6 hours when you use the handset continuously (talk
time).
• 5 days when the handset is not in use (standby).
When the Battery Needs Charging
• The phone will beep.
• The display will show "BATTERY LOW.”
When to Purchase a New Battery Pack
If the battery lasts only a few minutes even after a full charge, the usable life of the
battery has expired and needs to be replaced. Contact TT Systems LLC customer
support center by calling 1-800-955-1009 or on the Internet at
www.ttsystems.com.
BATTERY INSTALLATION
3.6 volt Ni Cd Battery