IBM -3460 Installation And Operating Manual - page 4
BATTERIES: CAUTION
To reduce the risk of fire or injury to persons, read and follow these instructions:
• For the cordless handset, use only 3.6V 600mAh Nickel Cadmium (Ni-Cd), cordless
telephone replacement battery pack (included).
• Do not dispose of the batteries in a fire. The cells may explode. Check with local codes
for possible special disposal instructions.
• Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause
damage to the eyes or skin. It may be toxic if swallowed.
• Exercise care in handling batteries in order not to short the battery with conducting
materials such as rings, bracelets, and keys. The battery or conductor may overheat
and cause burns.
• Do not attempt to rejuvenate the batteries identified for use with this product by
heating them. Sudden release of the battery electrolyte may occur causing burns or
irritation to the eyes or skin.
• When inserting batteries into this product, the proper polarity or direction must be
observed. Reverse insertion of batteries can cause charging, and that may result in
leakage or explosion.
• Remove the batteries from this product if the product will not be used for a long period
of time (several months or more) since during this time the battery could leak in the
product.
• Do not store this product, or the batteries provided with or identified for use with this
product, in high temperature areas. Batteries that are stored in a freezer or refrigerator
for the purpose of extending shelf life should be protected from condensation during
storage and defrosting.
Batteries should be stabilized at room temperature prior to use after cold storage.
IBM-3460 PARTS CHECKLIST
5
6
6. Short line cord for
wall installation
1
2
3
4
5
6
7
8
9
0
#
OPER
WXYZ
TUV
PQRS
MNO
JKL
GHI
DEF
ABC
NEW
CALL
VOLUME
REDIAL
FLASH
CHAN
TONE
CID
DELETE
MEM
MENU
HOLD
INTERCOM
FLASH
MUTE
REDIAL
CHARGE
IN USE
POWER
SPEAKER
PAGE
1
2
3
4
5
6
7
8
9
0
SPEAKER
VOL
ABC
DEF
JKL
MNO
TUV
GHI
PQRS
TONE
OPER
WXYZ
1. Handset
2. Base
3. AC power adapter
4. Reversible pedestal
7. Quick start card
3.6 volt Ni Cd Battery
5. 7-foot line
cord for desk use
QUICK START GUIDE
IBM-3460
1. Insert the pedestal into the slots on the
bottom of the base and slide up to lock in
place. The pedestal is reversible for desk
or wall mounting.
2. Connect the telephone line cord to the
LINE jack and to a telephone outlet.
3. Connect the AC power adapter to the
9V DC jack and to an AC outlet.
4. Raise the antenna vertically.
SETTING UP THE BASE
1. Slide open the battery door.
2. Insert the battery into the battery
compartment so that its connectors line
up with those on the handset.
3. Close the battery compartment door.
4. Place the handset on the base and allow
it to charge for 12 hours.
INSTALL THE BATTERY
1. Pick up the handset from the base.
2. Press P
. The display will show "CONNECTING". Once the IBM-3455 has
acquired a line the display will show the channel that it is using (eg.
CHANNEL 50). Wait until you hear a dial tone.
3. Dial the number you wish to dial.
4
When you are finished talking, press the P
key or place the unit back into
the base to end the call.
MAKING CALLS
3.
6
vo
lt
N
i C
d
B
at
te
ry
SEE INSTRUCTION
MANUAL
9V DC
LINE
POWER
8. Belt-Clip
9. Ni-Cd battery pack
BATTERY CAUTIONARY INSTRUCTIONS
The EPA certified RBRC® Battery Recycling Seal on the nickel-cadmium (Ni-
Cd) battery indicates TT Systems LLC is voluntarily participating in an industry
program to collect and recycle these batteries at the end of their useful life,
when taken out of service in the United States or Canada. The RBRC®
program provides a convenient alternative to placing used Ni-Cd batteries into
the trash or the municipal waste stream, which may be illegal in your area.
Please call 1-800-8-BATTERY for information on Ni-Cd battery recycling and
disposal bans/restrictions in your area. TT Systems LLC’s involvement in this
program is part of our commitment to preserving our environment and conserv-
ing our natural resources.
10. Headset