IBM ThinkPad 770 Installation Manual - page 11
Windows NT
Windows NT comes with a generic ATAPI CD-ROM device driver
that works with your computer's CD-ROM. The generic Windows NT
CD-ROM device driver is automatically installed during Windows NT
setup.
When you install this CD-ROM device after Windows NT is already
installed, add an ATAPI CD-ROM device driver according to the
following instructions:
If you are installing under Microsoft Windows NT 4.0:
1. Boot the system and log on with an administrator account.
2. Double-click on My Computer, Control Panel, and then
SCSI Adapter. The SCSI Adapter menu appears.
3. Click on the Drivers tab and then Add.... The selection list
menu appears.
4. Select Standard mass storage controllers as the
manufacturer, select IDE CD-ROM (ATAPI
1.2)/Dual-channel PCI IDE Controller as the SCSI adapter,
and click on OK.
5. Windows NT prompts you to restart your system. Click on
Yes.
If you are installing under Microsoft Windows NT 3.51:
1. Boot the system and log on with an administrator account.
2. From the Program Manager, double-click on Windows NT
Setup in Main.
3. Select Options, and then Add/Remove SCSI Adapters in
the pull-down menu. The SCSI Adapter Setup panel
appears.
4. Click on Add... to add a new driver. A message appears
explaining how to recover from a wrong installation.
5. Select OK. The Select SCSI Adapter Option menu
appears.
6. Select IDE CD-ROM (ATAPI 1.2)/Dual-channel PCI IDE.
7. Click on Install and follow the instructions.
8. When prompted; restart your system.
Part 2. Installation Instructions 2-5