IBM ThinkPad 770 Installation Manual - page 9
OS/2 Warp
To install the CD-ROM device driver for OS/2 Warp, follow these
instructions:
1. Turn on the computer. Start OS/2 Warp.
2. Double-click on OS/2 System.
3. Double-click on System Setup.
4. Double-click on Selective Install.
5. Select CD-ROM Device Support; then click on OK.
6. Select Non-listed IDE CD-ROM and click on OK; then click on
OK again at the System Configuration menu.
7. At the OS/2 Setup and Configuration menu, select Install.
8. Follow the instructions on the screen to complete the installation.
Software Parameters in the CONFIG.SYS File
When the CD-ROM device driver is installed in your computer, OS/2
automatically modifies the CONFIG.SYS file. The following
describes the parameters for the CD-ROM device driver in the
CONFIG.SYS file:
DEVICE=OS2CDROM.DMD [options]
This is the CD-ROM device class driver, where
options can be:
[/V]
Displays messages during the installation.
[/Q]
Does not display messages during the installation.
BASEDEV=IBMIDECD.FLT [option]
This is the IDE adapter device driver for ATA Packet Interface
devices, where
option can be:
[/V]
Displays messages during the installation.
IFS=[drive]:[path]CDFS.IFS [options]
This is the ISO9660/HSG file system for OS/2. All CD data
discs are recorded with this file format. where
options can be:
[/C:n]
Indicates how many 64-KB segments to use for the
sector cache. The default is n=2, two 64-KB
segments.
[/M:n]
Indicates the maximum number of file sectors to be
read at a time. The default is n=8, eight sectors.
[/V]
Displays messages on the computer screen during the
installation.
[/Q]
Does not display messages on the computer screen
during the installation.
You have now completed the modifications required for the CD-ROM
device driver.
Part 2. Installation Instructions 2-3