IC Realtime CONSOLE-5X User Manual - page 15
IC-CONSOLE-5X – User Manual
Com Configuration
Go to: Menu Settings > Zone.
The configuration for COM 232 & COM 485 is similar to that for a network configuration but
contains some notable differences listed below:
ID: 3 - This is the ID of the Zone of the Network connection, in order to have multiple
Network connections you will need to assign each Zone a unique ID ranging from 0 – 2048.
Name: Comlin – This is the identifier by which you will know which network that you are
adding. (Press SHIFT on the keyboard to cycle through numerals, uppercase and lowercase
letters).
Type: DVR – The type of device which you are connecting to. These can be DVR (Digital
Video Recorder, Network Video Recorder); SD (Speed Domes, PTZ’s); or NVS (Network
Video Server).
Link: COM 232 – This is the type of connection you wish to have going to your device it can
be any of: NET (Network, Ethernet connection); COM 232 or COM 485.
232Addr: 1 – This is the address of the COM 232 connection in case there are multiple 232
connections set up on the same range.
Rule: DH-2 – This is the unchangeable rule protocol for the connection to the keyboard.
BaudRate: 9600 – This is the baud rate for the device which you are trying to connect to.
The baud rate can be any of: 300, 600, 1200, 2400, 4800, 9600, 192000, 38400, 56000,
57600 or 115200.
DataBit: 8 – IC Realtime machines always have a default of Databit: 8. (5, 6 & 7 are also
available).
Parity: None – On IC Realtime recorders it always set to None. This can be set to Even, Odd
or None.
StopBit: 1 – On IC Realtime devices our default Stopbit is 1. This can also be set to 1.5 & 2.