IC Realtime IH-C6220 Quick Start Manual - page 9
8
Please note:
1) Frame Rate: Set to '30' as frame rate for NTSC and '25' as frame rate for PAL
standard.
2) Delete all: Click this button and then confirm. IHC6220 will restore default settings. Be
cautious!
3) Video format: Use WVGA only for best quality; WVGA resolution: 800x480.
A&C Manager
A&C manager interface is shown in Figure 3- 4.
Figure 3- 4
Under 'Local Config' interface, click on the 'A&C Manager' tab. The initial
IHC6220 password is '123456' and to unlock, input #123456#. Here you can change the
password, set the 'door unlock' response interval and unlock period timer.
FTP IP: FTP (File Transfer Protocol) is used in storing snapshots/video taken by the
IHC6220. Set the IP address of the FTP server you want to use.
FTP Port: The port associated with FTP server (typically 21 by default)
FTP User/Password: Set the user and its password to access the FTP server. Note to
make sure this user has rights to write/read new data to the server.
Issue card: On web-end, click on the 'Issue Card' button and put the IC Card (needs to be
13.56Mhz) on the card swiping area of the IHC6220. When you hear a beep sound, you
have successfully issued the card. You can use this new card to unlock the electronic
mechanism of the door it is attached to. (Access control module required)