ICanTek iCanView220 User Manual - page 14
iCanView220/220W User’s Guide
Rev.1.0 (Aug. 2006)
X[ \Z
connect the network camera directly to a hub supporting standard PoE.
iCantek assumes no responsibility for the damages caused by use of
standard PoE device with iCanTek’s products.
2. Apply power to iCanView220/220W
3. Install “IP installer” and “i-NVR” on your PC.
Detailed information for installing these programs can be found in
[IP-Installer User’s
Guide]
and
[i-NVR User’s Guide]
, respectively.
4. Assign IP address to iCanView220/220W using IP installer.
Identify the type of the network environment and set up IP address. Detailed process of
setting up IP address can be found in
[IP-Installer User’s Guide]
. If network type is
xDSL or Cable modem you need supplementary information provided by your ISP.
5. Connect to iCanView220/220W in Administrator Mode for initial parameter set-up.
All parameters are set to factory default state when iCanView220/220W is delivered. You
are asked to configure the system for your environment in administration mode. Detailed
information of using administration mode can be found in
[5.
Configuring
iCanView220/220W in Administrative Mode]
. Among the parameters, the parameters
in the following table should be set-up with proper values. Detailed information for the
parameters in Administrator Mode is found in
[5. Configuring iCanView220/220W in
Administrative Mode]
[Note]: Set-up values are preserved even the power is turned off.
Page
Parameter
Setup value
Factory default value
Video Size
Set
the resolution of the video
transmitted from iCanView220/220W.
Max Upload Rate
Set this value smaller than the upload
speed of your network.
Frame Rate
The number of frames
to be
transmitted per second.
Basic Setup
Video Rate
Bandwidth assigned
for video
transmitted from iCanView220/220W.
Make sure that you press Check
button to find out the number of
maximum possible simultaneous
users then set the number of
users smaller than or equal to the
number.
User Admin
& Time
Administrator
name &
For safety, you are recommended to
change these values from factory
Default value
User name : root