Iccons GTI-140 User manual - page 7
7
Serious Connections
TM
ICCONS™ GAS TOOL GTI-140 USER MANUAL
the power source.
•
If both lights are blinking in same pace,
remove the battery cartridge and plug
again.
•
If this happens continuously, the battery
cartridge may be damaged. Consult
authorized serviceman for replacement
of new battery cartridge.
NOTE:
•
Never attempt to open the charger or
battery cartridge.
•
The battery charger is for charging
specific battery pack. Never attempt
to charge battery pack from other
manufacturer’s battery cartridge.
Unsuitable battery cartridges may cause
fire that causes injury.
•
When the battery charger is being used,
keep out of direct sunlight.
•
To get better cooling effect, keep the
exhaust area clean.
5.2 Installing & Removing The Battery
Steps:
1. Empty fasteners from the magazine and
make sure the trigger is not pulled while
installing the battery.
2. To install the battery, insert the battery
cartridge until hearing a “click”.
3. Turn and lock the battery to avoid loosen
during shooting.
4. To remove the battery, turn to unlock,
grip the button at the back of battery
cartridge and pull out.
5.3 Battery Light Indicator
Green LED light
blinks every 0.5
sec under working
condition.
Battery level
sufficient for
working.
Red LED blinks
every 4 sec or keep
alighted under
working condition.
Low battery level,
need to unplug
and recharge
immediately.
Red LED blinks every
second. The tool has
entered protection
mode.
Stop using the tool
immediately and
consult authorized
serviceman for
maintenance
NOTE:
•
After using the tool, remove the battery
from the tool to prevent the tool from
being fired.