Iccons GTI-140 User manual - page 9
9
Serious Connections
TM
ICCONS™ GAS TOOL GTI-140 USER MANUAL
5.7 Loading The Pins
Caution !
•
Make sure the trigger is not held while
loading the pins.
•
Do not press on the surface ground
while loading.
Steps:
1. Insert the insulation fastener into the
barrel until it reaches the tip of pin guide.
2. For removing the insulation fastener,
simply pull the fastener out from the barrel.
5.8 Driving The Pins
Caution !
•
Please READ and UNDERSTAND the
section “General Safety Instructions”
for personal and working environment
safety.
•
If you spot of any abnormality about
the tool, contact nearest authorized
serviceman for inspection and repairing.
Steps:
1. Press the tool with suitable length of
insulation fasteners through the insulation
material.
2. Press the Nose of the contact arm
against working surface (90° against the
surface) firmly until you hear the fan motor
is working.
3. Pull the trigger, the pins are driven to the
object.
4. Release the trigger and lift the tool.
5.9 Cleaning the Filter
The filter at the back of the tool acts
crucially to suck in air into the chamber. For
maintaining the best performance of the tool
users should always keep it clean.
1. Unscrew four screws on the back cover
2. Take out the back cover and clean the
mesh with brush or air.
3. Put the back cover on the machine and
fasten with four screws.
NOTE:
•
Do not attempt to use water to clean the
mesh. The cover and mesh must be dry
when operating the tool. If wet it may
easily cause malfunction to the tool.