ICentral System One M200 Installation Manual - page 35
31
31
– This test will display the image from the camera or other video device connected
to CAM 1 input.
– This test will display the image from the camera or other video device connected
to CAM 2 input.
– This test will display the image from the camera or other video device connected
to CAM 3 input.
Note: Any video fault could be related to a fault with the camera or connecting cable but it could also be related
to a fault with the particular camera input. If one input works but another does not, simply swapping the
devices at the inputs will indicate whether the fault is with the camera/cable or video input.
RADIO/CLOCK ADJUSTMET (AM/FM MODEL)
With the time displayed (Radio off):
Press the "Mem" button, causing the minutes to flash.
Use the "Up" and "Down" buttons to adjust the minutes.
Press the "Mem" button, causing the hours to flash.
Use the "Up" and "Down" buttons to adjust the hours.
Note: Cycle the hours through 12 hours to change AM/PM
Press the "Mem" button, to exit “time set” mode.
Press the “Mus” button at the Master, so the red LED illuminates.
Turn the radio on, by pressing the “Power” button at Master.
Tune to the desired frequency, using the “Up/Down” buttons.
Allocate a preset memory location if desired, by pressing the “Mem” button, followed by a
preset number, followed by the “Mem” button again.
Use the Volume – and + buttons to adjust the volume at each station
Note: Radio will only be at heard at stations set to Music mode (Red LED illuminated)
The overall radio volume for the whole system can be adjusted if required using the Audio
Options Menu in program mode.