Iclebo Arte YCR-M05 User Manual - ●
OPEN
8
1. After turning over robot vacuum, identify the position of
the left and right side brushes.
2. Match the L side brush to the L marked part in the direction
as the groove, then push in firmly.
3. Match the R side brush to the R marked part in the direction
of the groove, then push in firmly.
1
2
Mop Plate
There are no batteries inside the remote controller at the time of purchase.
Install 2 x AAA batteries before using the remote contol.
1. Push the cover of the backside of the remote controller downward to open.
2. Check (+)(-) of the batteries and install.
3. Match the cover to the groove, and close until “click” sounds.
1. Turn over the robot vacuum, and install the Mop Plate by combining it to the fixing part of the main body.
2. If Mopping mode is not used, separate and keep the Mop Plate saperate from the Main Body.
※ In Mopping mode with mop plate attached, there may be cases that it is blocked by carpet, rug, or doorsill, and
cannot go forward normally, so be careful. In such cases, moving the rug or carpet to one side and using Mopping
mode is recommended.
※ In some floor environments, there may be cases of not being able to go forward normally. If it cannot go forward
normally in the floor environment of marble floor or certain patterns, then also set Climb mode for cleaning.
Ultra Microfiber Mop
●
Installing the r
obot c
leaner
Check list before using
Assemble side-brush
Insert remote control battery
Assemble Ultra Microfiber Mop
Fit the side brush into the protruding part of the robotic
vacuum cleaner matching the same shape.