Iclebo YCR-M05 User Manual - ●
3
9
Precaution before using
Open the cover of the backside of the charging station,
and install the adapter with connected power plug as
in the figure.
1. Turn on the power switch on the side of the product.
3. The battery is fully charged, the battery status on display will be green.
2. Match the charging pin on the bottom of the main body with the socket of the charging station
correctly, and the robot changes to charing mode.
▶▶ Robot starts to charge with blinking battery status on the display window.
※ Change of the Charging Indicator status on Charging Station
Red: robot cleaner is in operation away from the docking station, or the charging connector
between the cleaner and docking station is not properly connected.
Green Blinking: Recharging (Remaining battery is 40% or less)
Green: Recharge completed (Battery is fully charged or over 40% charged)
[Auto-charge during use]
※ When the battery is low during an operation, this product moves to the charging station and
performs auto charging.
※ If the base button of the remote control is pressed, it finds and moves to the charging station
and starts charging.
Battery is discharged at the time of the purchase of the product,
so it must be fully charged before using the robot for the first time.
Installation of
charging
station
1
4
Charging
1
2
3
Max
90
AUTO
Max
15
30
90
●
IN
S
T
A
L
L
IN
G
T
H
E
R
O
B
O
T
C
L
E
A
N
E
R
※How to connect adapter
2