Icom ID-RP1 Instruction Manual - ■ Microsoft
10
3
DRIVER INSTALLATION
2001 NEW
2001 NEW
■ Microsoft
®
Windows
®
98/Me
q Connect the ID-RP1D/VS [SERVICE ] connector
and the PC USB port through an USB cable and
connector converter.
• Turn the power ON.
• “New Hardware is found” dialog box appears.
w The “Add New Hardware Wizard” will come up as
below. Click [Next>].
e Select “Search for the best driver for your device
(Recommended).”, then click [Next>].
r Select “CD-ROM drive,” and insert the supplied CD
into the drive, then click [Next>].
t When the driver is found, the following dialog is dis-
played. Click [Next>] to start the installation.
NOTE: When the appropriate driver is not found, a
different dialog is displayed. In such case, select
“Specify a location” and type “D:\driver” in the text
box to select the “Driver” folder in the CD (if CD
drive is D) in step r.
y After the installation is completed, the following dia-
log is displayed. Click [Finish] to finish the installa-
tion.
u The “Add New Hardware Wizard” will come up
again as below. Click [Next>].
Click
Click
Click
Click
Select
Click
Select
Click
ID-RP1.qxd 02.12.17 11:43 Page 10