Icom ID-RP1 Instruction Manual - Setting The Repeater
5
17
SETTING THE REPEATER
2001 NEW
■ General
The ID-RP1 TX/RX module maintenance programs re-
peater operating frequencies, and the ID-RP1D main-
tenance programs call signs for the repeaters.
■ Repeater frequency setting
q Connect the PC and either ID-RP1D or ID-RP1VS
[SERVICE] connector using the USB service cable.
• The connector converter for the ID-RP1VS has 2 USB
connectors for setting receive and transmit frequencies
independently.
w Turn the repeater unit power ON.
e Select the “ID-RP1 TX/RX module maintenance”
menu in the program menu to start up the applica-
tion.
r Click [SETUP].
t Enter the appropriate USB port number in the “Port
Number” cell, then click [Set].
• The BaudRate is the fixed value.
• The screen disappears after clicking [Set].
• This setting is necessary for the first time only.
y Click [Edit] to displays the frequency setup screen.
• The displaying screen is different according to the con-
nected unit and port.
u Enter the desired frequency in the Frequency cell,
then click [Store].
• After clicking [Store], the screen disappears.
• When connecting to ID-RP1D
• When connecting to ID-RP1VS
i Click [EXIT] to quit the application.
Enter the desired
frequency here.
Click
Enter the desired
frequency here.
Click
Click
Enter the appropriate
port number here.
Click
Click
• ID-RP1D
• ID-RP1VS
to [SERVICE]
USB1
for transmit
USB1
USB2
for receive
to [SERVICE]
to PC
to PC
ID-RP1.qxd 02.12.17 11:43 Page 17