Icom RS-RP2C Setup Instructions - page 10
8
2
SYSTEM SETUP
■ Control software settings
D
D dsgwd.conf screen description
— Zone Repeater’s Information —
q ZR_ADDR
Sets the zone repeater’s IP address
(the IP address
n in D Setup Example)
.
The same IP address that is programmed in “IP”
(for
the ID-RP1D maintenance)
or “IP Address”
(for the util-
ity for ID-RP2C)
cell in “Communication Settings”
should be set.
w ZR_CALLSIGN
Sets the zone repeater’s call sign.
The same call sign that is programmed in “Callsign”
cell in “General” of the ID-RP1D maintenance or the
utility for ID-RP2C should be set.
e ZR_PORT
Sets the zone repeater’s transmit/receive port num-
ber
(the port number n in D Setup Example)
.
The same port number that is programmed in “Port”
cell in “Communication Settings” of the ID-RP1D
maintenance or the utility for ID-RP2C should be set.
— DNS Server’s Information —
r DNS_ADDR
Sets the zone DNS server’s IP address
(the IP ad-
dress c in D Setup Example)
.
t DNS_MAC
Sets the zone DNS server’s MAC address
(the MAC
address c in D Setup Example)
.
Set the MAC address of the connected router with
dividing by hyphen (-).
— GW’s Information —
y GW_ETHIFNAME
Sets the interface name of the LAN card
(the inter-
face name v in D Setup Example)
.
The interface name can be confirmed with the “if-
config” command.
u GW_VCPORT
Sets the port number for voice operation
(UDP)
.
Use the default setting.
i GW_DTPORT
Sets the port number for data operation
(TCP)
.
Use the default setting.
o GW_ZRPORT
Sets the port number of the gateway server self for
the communication with the zone repeater
(UDP)
.
Use the default setting.
— IP Server’s Information —
!0 MGSV_QRPORT
Sets the port number of the IP address managing
server for call sign inquiry
(UDP)
.
Use the default setting.
!1 MGSV_UDPORT
Sets the port number of the IP address managing
server for updated location information request
(UDP)
.
Use the default setting.
— GW connection —
!2 CON_WAIT_INTERVAL
Sets the application timer.
The application timer is the waiting timer
(unit: sec-
ond)
until the connection is succeeded when mak-
ing a new connection to another gateway in data
mode operation.
Use the default setting.
!3 CON_REFRESH_INTERVAL
Sets the decide timer
(unit: second)
to impossible to
connect to the gateway which is failed in connection
once in data mode operation.
Use the default setting.
!4 CON_MAX_GW
Sets the maximum number of simultaneous con-
nections to another gateway in data mode opera-
tion.
Use the default setting.
q
w
e
r
t
y
u
i
o
!0
!1
!2
!3
!4