ICON Health & Fitness Weider WEEVBE13340 User Manual - page 6
6
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two persons.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the inversion table, make sure
all parts are oriented as shown in the drawings.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
The following tools (not included) are required
for assembly:
• Two adjustable spanners
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end span-
ners, or a set of ratchet spanners.
Make Things Easier for Yourself
This manual is designed to ensure that the
inversion table can be assembled successfully
by anyone. Most people find that by setting
aside plenty of time, assembly will go smoothly.
ASSEMBLY
1.
Open the Front and Rear Frames (5, 6), and
push down on the Linking Bars (7, 8) so that they
are straight across as shown.
2.
Insert the end of a Pivot Bar (23) with the adjust-
ment holes into the bracket on one side of the
Backrest Frame (1). Engage the pin on the
Backrest Frame into the centre adjustment hole.
Repeat this step with the other Pivot Bar (23).
1
2
6
5
8
8
Pin
7
7
23
23
1
Adjustment
Holes
11
2
Straps
TIGHTENING THE BACKREST
The Backrest (2) may stretch as it is used. If this hap-
pens, tighten the five straps on the back of the
Backrest.
15
39
14
4
Front
Rear
14
USING THE ANKLE LOCK
To secure your ankles in the inversion table, stand on
the Foot Plate (4) with the backs of your legs against
the rear Round Foam Pads (14) and your toes under
the front Round Foam Pads. Pull the Ankle Lock (15)
toward the Adjustment Leg (3) so that the front Round
Foam Pads are tight against your ankles.
To release the Ankle Lock (15), push the top of the
Adjustment Cap (39) down and move the Lock for-
ward.
ADJUSTING THE ADJUSTMENT LEG
The length of the Adjustment Leg (3) can be adjusted
to correspond to the height of the user. Remove the
Pin (30) from the Backrest Frame (1). Pull the Large
Knob (27) out as far as it will go. Slide the Adjustment
Leg into, or out of, the Backrest Frame so that the
first or second measurement greater than the user’s
height is covered by the Backrest Frame. Re-engage
the Knob and Pin into adjustment holes in the
Adjustment Leg and the Backrest Frame.
Use the inversion table with the Adjustment Leg (3)
adjusted to a few different lengths to determine which
length is best for you.
WARNING:
The inversion table is
designed to be used by persons 198 cm (6 ft. 6
in.) tall or less.
WARNING:
Always make sure the
Ankle Lock (15) is secured snugly against your
ankles before using the inversion table. Always
wear athletic shoes with laces to help secure
your feet in the inversion table.
30
1
3
Adjustment
Hole
Height
Measurements
3
27