ICON Health & Fitness Weider WEEVBE13340 User Manual - page 8
8
7.
Attach the Strap (17) to the crossbar on the Front
Frame (5). Attach the Clip (32) on the Strap to the
hook on the bottom of the Backrest Frame (1).
6.
Remove the Pin (30) from the Backrest Frame (1).
Pull the Large Knob (27) out as far as it will go.
Next, insert the Adjustment Leg (3) into the
Backrest Frame. Engage the Large Knob into an
adjustment hole in the Adjustment Leg.
Insert the Pin (30) into the Backrest Frame (1)
and the Adjustment Leg (3).
Note: The Adjustment Leg (3) should be posi-
tioned at the height measurement that is one
or two inches greater than the height of the
person using the inversion table.
3
30
17
5
32
1
27
1
Adjustment
Holes
Height
Measurement
6
7
9
8.
Attach the Right Handlebar (21) to the M8 x
30mm Bolts (45) on the Front and Rear Frames
(5, 6) with two M8 Nylon Nuts (40).
Make sure
the Handlebar is oriented as shown.
Repeat this step with the Left Handlebar (9).
10.
Make sure all parts are properly tightened
before using the inversion table. The use of
parts will be explained in ADJUSTMENTS, begin-
ning on the following page.
9.
Cover the right Saddle Plate (20) with the Right
Cover (12). Tighten a Small Knob (46) into the
Right Handlebar (21).
Repeat this step with the Left Cover (11).
8
9
21
45
45
6
5
40
12
11
20
21
46
9