ICON i-Controls Pro User manual - Status Selector
Select your desired MIDI functions for the buttons.
Select your desired MIDI functions for the jog wheel
Select the Mackie Control mode according to your DAW or Traktor mode
for “MIDI Learn' at the pull-down menu for layer 1. It will switch to “User
define” mode automatically if you switch to layers 2, 3 & 4.
Select “Master” if you are using iControls Pro as a standalone device or
select “Slave” if it is cascading with an i-Pro series controller.
Click this button to save your current settings for the iControls Pro. The file
is an “.iControlsPro” file.
Click this button to load a previously saved “.iControlsPro” setting file for
your iControls Pro.
Click this button to upload the iMap software settings to your iControls
Pro via USB connection.
Click this button, a MIDI device select window
will appear as shown in diagram 1. Please select
“ICON iControls Pro” for the MIDI Out Devices.
Click this button to enter into the firmware upgrade window for iControls
Pro. Please refer to P.11 for the firmware upgrade procedure.
Select your desired MIDI functions for the knob.
Assign MIDI functions to the knobs
(User define mode only)
Assign MIDI functions to the buttons
Assign MIDI functions to the Jog wheel
Mode selector (Layer 1 only)
Status Selector
Save file” button
“Load file” button
“Send Data” button
MIDI Devices” button
“Firmware Upgrade” button
(User define mode only)
(User define mode only)
Tips: A Mackie Hui mode will be added soon, please check our official website
for updates.
(Note: You must have connected your iControls Pro to your Mac/PC, otherwise
the settings upload will not be successful.)
“
“
TM
Diagram 1