ICON I-DJ Owner's manual - Imap Idj Software Panel
TM
iMap iDJ software panel
(continues)
Assign the MIDI channel & CC number to the scratch wheel (A & B)
Select your desired MIDI channel (1-16) and CC number (0-127) in the pull-
down menu for each scratch wheel. There are four values that you could set
for each scratch wheel as below:
1) Value 1: Setting the midi data for rotating the scratch wheel (right or
left direction) with “Vinyl Mode” button activated.
2) Value 2: Setting the midi data for rotating the scratch wheel (right or
left direction)
3) Value 3: Setting the midi data for rotating the scratch wheel's rubber
ring (right direction).
4) Value 4: Setting the midi data for rotating the scratch wheel's rubber
ring (left direction).
Assign the MIDI channel & CC number to the touch-sensitive element
(scratch wheel A & B)
Select your desired MIDI channel (1-16) and CC number (0-127) in the pull-
down menu for the touch sensitive element.
Assign the MIDI channel & CC number to the fader (Tempo)
Select your desired MIDI channel (1-16) and CC number (0-127) in the pull-
down menu for the fader. There are two values that you can set for this fader
as below:
1). Value 1 – Setting the midi data for sliding the fader.
2). Center – Setting the midi data for sliding past the center position
of the fader.
Assign the MIDI channel & CC number to the fader (PGM1 & PGM 2)
Select your desired MIDI channel (1-16) and CC number (0-127) in the pull-
down menu for the fader.
Assign the MIDI channel & CC number to the fader (crossfader)
Select your desired MIDI channel (1-16) and CC number (0-127) in the pull-
down menu for the fader.
Assign the MIDI channels and CC number to the control buttons
There are 24-control buttons on iDJ you may assign. Select your desired MIDI
channel (1-16) and CC number (0-127) for the control buttons.
Assign the MIDI channels and CC number to the knobs
There are 14 control knobs on iDJ you may assign. Select your desired MIDI
channel (1-16) and CC number (0-127) for the knobs. There are two values
that you can set for each knob as below:
1). Value 1 – Setting the midi data for rotating the knob.
2). Center – Setting the midi data for rotating past the center position
of the knob.
1
2
3
4
5
6
7
11